By using two resistors and a single capacitor with second-generation differential current
conveyor as an active element, a new square wave generator is proposed and …

In this paper, a novel two-input two-output current-mode (CM) circuit for providing
proportional-integral-derivative (PID) controller and instrumentation amplifier (IA) responses …

This brief presents a new low-power miniature instrumentation amplifier based on the
operational floating current conveyor (OFCC). The OFCC is a general-purpose current mode …

Physiological information provided by bio-potential signals is essential and pivotal for
biomedical sensors. As the first stage in the signal chain of the sensor, impedance matching …

In this paper, a Current Mode Instrumentation Amplifier (CMIA) is presented. The proposed
circuit employs two Extra X Current Controlled Current Conveyors (EX-CCCII) and a single …

A new approach to the design of an instrumentation amplifier using only 2 CMOS current-
controlled conveyors and an active resistor is introduced. The new approach, which has no …

This study presents a DVCC-based voltage-controlled dual slope operation
square/triangular wave generator. The proposed configuration uses two differential voltage …

This paper proposes two generalised instrumentation amplifier topologies which can
operate in voltage, current, transadmittance, and transimpedance mode. Each topology is a …

In this paper, analysis and design of a new current-mode instrumentation amplifier (CMIA)
circuit is presented. The proposed circuit employs two Current Operational Amplifiers (COA) …

In this paper, a novel topology for implementing resistor-free current-mode instrumentation
amplifier (CMIA) is presented. Unlike the other previously reported instrumentation …