All‐solid‐state batteries with an alkali metal anode have the potential to achieve high energy
density. However, the onset of dendrite formation limits the maximum plating current density …

Electrohydrodynamic printing holds both ultrahigh-resolution fabrication capability and
unmatched ink-viscosity compatibility yet fails on highly insulating thick/irregular substrates …

Injection molded direct joining (IMDJ) is a promising metal–plastic direct joining method to
make products lighter. IMDJ first treats the metal surface and then injects melted plastic onto …

Stress corrosion cracking (SCC) of two lower-copper Al–Zn–Mg–Cu alloys, AA7079 and
AA7022 (0.6–0.9 wt% Cu), and a higher-copper AA7075 (1.5 wt% Cu) alloy are reported. In …

The subject of this study is an investigation of the influence of storage conditions of
AlSi10Mg powder on the LPBF parts. For this purpose, powders that were stored and aged …

A combined electrochemical impedance spectroscopy (EIS) and X-ray photoelectron
spectroscopy (XPS) approach showed that the corrosion behaviour of 5083 Al alloy was …

Fabrication of nanoporous metal core/oxide shell structure using equiatomic AlCoCrFeNi
high entropy alloy (HEA) and its electrochemical property as supercapacitor electrode have …

The effects of temperature and dissolved oxygen on the passivation behavior of Ti–6Al–3Nb–
2Zr–1Mo alloy in artificial seawater are investigated. The increase of temperature increases …

The microscopic mechanisms underpinning the spontaneous surface passivation of metals
from ubiquitous water have remained largely elusive. Here, using in situ environmental …

Al-air batteries (AABs) have been regarded as a promising new energy source. However,
the self-corrosion of Al anode leads to a loss of battery capacity and a decrease in battery …