The microstructural characteristics of the high pressure die casting (HPDC) AlSiMgMnCu
alloys in the skin layer, segregation band and the central zone were investigated in three …

Solidification behaviour of the liquid in semisolid Al–7Si–0.6 Mg slurry in the rheo-diecasting
process has been investigated. It was found that the intensive shearing not only influences …

Cast specimens of Mg and of several Mg-Zn binary alloys with a wide range of grain sizes
were deformed in tension and compression. The k values calculated from the Hall–Petch …

The characterization of externally solidified crystals (ESCs) and porosities in a high-pressure
die-cast AlSi10MnMg alloy was investigated using optical microscope (OM) and computed …

Bands of positive macrosegregation and porosity commonly follow the surface contour of
components produced by high-pressure die casting (HPDC). In this article, Al alloy AlSi7Mg …

The effect of chromium concentration on the microstructure and mechanical properties of a
high-pressure die-cast AlSi9Cu3 (Fe) alloy is reported. The Cr content ranges within the …

The effects of varying Mg and Si levels on the microstructural inhomogeneity and eutectic
Mg 2 Si morphology in die-cast Al–Mg–Si alloys have been investigated. It was found both …

The fracture behavior of a high pressure die casting AlSi10MnMg alloy with varied porosity
levels is investigated by synchrotron radiation X-ray computed tomography. Attention is …

Understanding microstructure formation during high-pressure die casting (HPDC) is
important for the effective quality control of high-pressure diecast aluminum-alloy …

This encyclopedia, written by authoritative experts under the guidance of an international
panel of key researchers from academia, national laboratories, and industry, is a …