This paper addresses an approach based on the Taguchi method with gray relational
analysis for optimizing the turning parameters of hardened DIN 1.2344 hot work tool steel …

This study evaluated the effects of cutting tool coating type and process parameters on flank
wear and surface roughness in the turning of hardened 1.2343 hot work tool steel. Two …

Bu çalışmada AISI 304 ve AISI 316 östenitik paslanmaz çeliklerin işlenebilirliğini
değerlendirmek amacıyla kaplamasız tungsten karbür kesici takımlar kullanılarak tornalama …

Graphite, due to its hexagonally arranged crystal structure, is a preferred lubricant. The
crystal structure within a planar condensed ring system indicates that the layers are stacked …

In the present work Taguchi method is used to optimize cutting parameters during dry
turning of AISI 304 austenitic stainless steel with AlTiCrN coated tool. The coating was …

The experimental investigations of the tool wear in turning of EN 31 alloy steel at different
cutting parameters are reported in this paper. Mathematical model has been developed for …

Purpose In the current scenario, new materials are gaining popularity due to higher specific
properties of strength and stiffness, increase in wear resistance, dimensional stability at …

In this study, Ti-6Al-4V was machined under high pressure cooling conditions. Cutting
parameters which were assumed as independent variables are consist of 4 different levels …

Low-voltage (LV) fuse systems, which open a circuit by cutting the current when it exceeds a
given value for an adequate period, are used in nonresidential, commercial, and industrial …

The aim of the present study is to investigate the effects of physical vapour deposition (PVD)
and chemical vapour deposition (CVD) coated cemented carbide inserts on the surface …