At present, most carbon fibres are used as reinforcement for polymers. Fabrication
technologies for carbon-fibre-reinforced polymers (CFRPs) are now reaching a mature state …

The effect of tin content in an Al-Sn alloy in the range from 0 to 100 at.% on its mechanical
properties was studied. An increase in the tin content leads to a monotonic decrease in the …

A brief review of the methods of fabrication of single crystalline oxide fibres is presented. It is
shown that the internal crystallisation method (ICM), that is crystallisation of the fibres in …

A new type of composites containing eutectic oxide fibres and a high entropy alloy (HEA)
with a melting point of about 1450° C as the matrix is obtained via liquid infiltration route. A …

NiAl-based electrodes of a required size were fabricated by combined use of centrifugal
SHS casting and induction remelting in an inert atmosphere and characterized by modern …

Three families of metal matrix fibrous composites are considered in the paper as potential
candidates for future heat resistant materials. Strength, fracture toughness, creep resistance …

Reinforcing a molybdenum matrix with appropriate oxide fibers slows down oxidation of
molybdenum at high temperatures. At the same time, oxide fibers crystallized from the melt …

Современное композитоведение обязано своим рождением композитам с
металлической матрицей. Однако, родившись, по-видимому, несколько …

Oxide fiber-reinforced Ni-base composites have long been considered as attractive heat-
resistant materials. After several decades of active research, however, interest in these …

Nickel matrix composites reinforced with different weight percent of alumina short fibres
have been fabricated by powder technology route. The alumina short fibres were …