An improved thermomechanical processing double step hot rolling (DHR) was proposed to
manufacture fine-grained Al-Zn-Mg-Cu alloys based on pre-deformation, short time …

An improved double step hot rolling (DTR) processing was proposed to manufacture fine
grained Al–Zn–Mg–Cu alloys based on pre-deformation, short-period annealing and final …

An improved TMT (thermomechanical treatment) double step hot rolling (DR) including low-
temperature pre-deformation, intermediate short-term annealing and final hot rolling, was …

A special thermo-mechanical treatment (ST) process involving two stages of deformation
was studied, and the influence mechanism for the first stage of deformation (pre …

An improved low-temperature thermo-mechanical treatment (LTMT based on DYA: dynamic
aging) aiming to discover the action of deformation-induced precipitation to microstructures …

This study investigated the effect of intermediate annealing (IA) during a special thermo-
mechanical treatment on the microstructure and properties of 7185 Al alloy. The results …

In this study, a new generation of ultra-high strength 7185 aluminum alloy and nano-sized
TiC+ TiB 2 particles reinforced 7185 alloy matrix composites (PRAMCs) were prepared, and …

Abstract Ultra-high strength Al-Zn-Mg-Cu alloy is a promising lightweight structural material,
and there is still room to improve its mechanical property. As a typical precipitation …

In this paper, the microstructure evolution, mechanical properties and corrosion behavior of
7003 aluminum alloy under dynamic aging (DYA, including rolling deformation and final …

摘要利用TEM, XRD, SEM, DSC 以及室温拉伸等方法, 研究了预变形对超高强Al-Zn-Mg-Cu
合金组织与性能的影响. 通过对比未经预变形和预变形量为3% 及4% 的Al-Zn-Mg-Cu …