Despite of more than two decades of research in white etching areas (WEAs), this
phenomenon still persists in wind turbine gearbox bearings leading to a reduction of L 10 …

Abstract Analysis of publications has shown that the use of the exothermic addition with a
combined oxidizer (x CuO+(x-1) Fe2O3-Al) as components of filler materials will reduce …

Abrasion-resistant materials for rock-facing applications typically display low fracture
toughness. For materials selection, available fracture data are limited, due to the cost of …

NbC-based hardmetals are technologically employed as metalworking tools in bulk form but
have scarcely been investigated as coatings. Following a previous report on High Velocity …

An improved approach is presented for the estimation of carbide volume fraction (CVF) in as-
cast High Chromium Cast Iron (HCCI) alloys using Machine Learning (ML) techniques. The …

A type of Cr12Mo1V1 electric connection die occured brittle fracture after 200 times of
service, and its life was much lower than the design life of the die. In this paper, the 5M1E …

This research focuses on the erosion wear behaviour of two Fe-Cr-C alloys with similar
chemical compositions obtained using different production methods. The first alloy belongs …

Gas-Shielded Tungsten Arc Welding (GTAW) was modified to a Flux-Cored-Double-Wire
GTAW (FCDW-GTAW); in this technique, wires of different compositions are used …

Produžetak radnog veka kritičnih komponenti industrijskih sistema je moguć kroz izbor i
ugradnju pravilno projektovanog materijala. Pri jednom takvom izboru potrebno je izvršiti …

Carbides and Nitrides of transition metals are widely used due to their interesting properties.
Several deposition methods and techniques can be used to produce carbide and nitride …