摘要目前, 微加工和精加工技术的迅速发展对微型化加工技术提出了更高的要求:
将加工尺度提高到微米甚至纳米级, 并且能够在材料内部实现三维立体微加工 …

The improvement of aero-engine performance posed a challenge to the heat dissipation
ability of blades, resulting in a substantial increase in the demand for micron-sized (≤ 1 mm) …

A two-step femtosecond-pulsed laser deposition (fs-PLD) process is reported for the rapid
development of uniform, poreless, crack-free, and well-adhering amorphous coatings of …

Ablation of copper using multipulse femtosecond laser irradiation with an 800 nm
wavelength and 120-fs pulse duration is investigated theoretically. A two-temperature …

In order to improve the oxidation resistance of a carbon/carbon (C/C) composite finger seal
in high-temperature environments, a high-repetition frequency femtosecond laser was used …

The coloration of a copper surface after treatment in air with femtosecond laser pulses at
changing only the scanning direction has been studied. Surface structures with low spatial …

Abstract SnS (S1) and SnS 0.4 Se 0.6 (S2) thin films were prepared using thermal
evaporation on annealing at 523 K of the thermally deposited films. Compositional analysis …

Recently a contact solid carburization method to fabricate carbide coatings on refractory
metals was proposed. The principle is to hot-press the refractory metal with a “carbon …

Surfaces with fluid repellency are of great interest for a plethora of applications and
introduction of the concept of wettability contrast has further expanded their application …

Thin coatings of Cr 2 O 3 have been used for numerous applications. Selective oxidation of
chromium will be beneficial for integrated device fabrications. Thin coatings of pure …