Hydroforming is a modern metal-forming process prominently used in the shipbuilding,
aerospace, and automotive industries for forming lightweight, complex-shaped geometries …

Producing conical parts from sheet metal is a highly intricate process that poses significant
challenges in the manufacturing industry. To investigate the ductility of an AL-1050 conical …

Achieving sharp corners without defects such as thinning and fractures is a primary objective
in the manufacturing of double-stepped tubes. Therefore, selecting the optimal tube …

The paper describes the pack siliconizing optimization procedure for AISI D2 tool steel. Pack
siliconizing was performed by employing different treating temperatures (falling in the range …

The process of formation of surface layer on steel AISI D2 pack siliconized at 650, 800 and
950° C for 2, 3, and 4 h using a powder mixture (in wt.%) of 0.5, 0.75, 1.0 NH4Cl+ 12 Si, the …

Driveshaft is a small spring coil (usually less than 1mm in diameter), made by several
stainless-steel wire filaments, which transmits force and motion to the body through existing …

Nowadays, due to importance of the lightweight materials in industries and reducing the
consumed energy, obtaining a lightweight material with high strength and stiffness is …

Аннотация Исследован процесс формирования поверхностного слоя на стали AISI D2
при пакетном силицировании при температурах 650, 800, 950 С длительностью 2, 3, 4 ч …

Исследован доэвтектический сплав Al-11% Si и заэвтектический сплав Al-20% Si после
двухэтапного модифицирования поверхности, сочетающего электровзрывное …