Electricity is an efficient form of energy, and the growing interest in electricity-assisted
manufacturing is motivated by its inherent energy saving and reduced environmental impact …

The technology of high-density electropulsing has been applied to increase the performance
of metallic materials since the 1990s and has shown significant advantages over traditional …

M50 bearing steel, as the important material used in aeroengine bearing, exhibits low cold
working capacity with high susceptibility to produce voids. This would lead to the …

To improve the mechanical properties of the pre-deformed SUS 304 ultra-thin strip by
regulating its microstructure, the paper uses high energy pulsed current to treat the pre …

A review of the experimental and theoretical research on electroplastic deformation of
metals is presented herein. We focus on the fundamental physics of electro-mechanical …

The local stress concentration created by the seam welding process often reduces the
fatigue life of the material along and around the seam. Post-welding heat treatment is …

The effects of electropulsing treatment (EPT) and annealing on the tensile behaviors of
twinning-induced plasticity (TWIP) steel after interrupted tension are compared. It is found …

The research about repair of metal cracks plays an important role in promoting the
development of remanufacturing engineering. Crack in the SUS304 stainless steel was …

Outstanding combination of strength and ductility of the Al-Mg-Li alloy could be achieved
using the efficient and energy saving route of cold rolling combined with two steps of …

The voids caused by the cold rolling (CR) quite deteriorates the final performance of M50
bearing steel. In this work, the effect of electropulsing treatment (EPT) on the voids has been …