With the increased pressure to decarbonise the power generation sector several gas turbine
manufacturers are working towards increasing the hydrogen-firing capabilities of their …

Several valuable biologically active molecules can be obtained through C–H activation
processes. However, the use of expensive and not readily accessible catalysts complicates …

The paper presents the results of the analysis of the resistance to hydrogen and high-
temperature salt corrosion of the developed alloy of the CM88Y type for the turbine blades of …

We develop a heat-resistant corrosion-resistant alloy based on nickel and alloyed with
rhenium and tantalum. This alloy is intended for the production of blades for a new …

We perform experimental investigations of the fatigue fracture of turbine blades in the
second stage of power gas-turbine engines. The blades were made of a specially …

Changes in the properties of 38KhN3MFA steel, from which the rotor shaft is made, were
investigated by comparing the hardness of the shaft surface and hydrogen concentration in …

We analyze the influence of structure on the physicomechanical properties of a refractory
corrosionresistant alloy doped with rhenium and tantalum (4.07 and 2.62 wt.%, respectively) …

The ratio of alloying elements K γ which can be used for estimation of mechanical
properties, taking into account the complex influence of the main components of an alloy, is …

We study the influence of alloying with cobalt (13.0 and 18.5 wt.%) and hafnium (0.3 and 0.7
wt.%) on the hydrogen embrittlement and salt corrosion of cast nickel alloy containing (wt.%) …

The influence of hydrogen at pressures up to 65 MPa on the strength, plasticity, and low-
cycle fatigue life of the KhN60KMUBTF alloy samples at temperatures of 293–1073 K, short …