Miniaturisation of the toroidal fluidisation concept using 3D printing

JR McDonough, R Law, DA Reay, D Groszek… - … Research and Design, 2020 - Elsevier
We used the stereolithography printing technique to fabricate a toroidal fluidised bed
(TORBED) at the smallest scale ever achieved (50 mm diameter with 10 mm annular width) …

An eulerian-eulerian CFD simulation of air-water flow in a pipe separator

EA Afolabi, JGM Lee - The Journal of Computational …, 2014 - journals.sagepub.com
This paper presents a three dimensional Computational Fluid Dynamics (CFD) of air-water
flow using Eulerian–Eulerian multiphase model and RSM mixture turbulence model to …

The effect of different geometrical configurations of the performances of Gas-Liquid Cylindrical Cyclone separators (GLCC)

HM Kha, NN Phuong, NT Nam - 2017 International Conference …, 2017 - ieeexplore.ieee.org
Gas-Liquid Cylindrical Cyclone (GLCC) separator is widely used in the petroleum industry
with potential fields of applications. Its performance is strongly influenced by the inlet …

Numerical simulation of oil separator of an automotive swash type compressor

S Sen - 2018 - sae.org
In the present study a numerical investigation is performed by using computational fluid
dynamics (CFD) aiming to figure out and maximize the separation efficiency of an oil …

[PDF][PDF] THESE EN COTUTELLE

M Lazrag - 2016 - docnum.univ-lorraine.fr
Ce travail de recherche a été réalisé dans le cadre d'une thèse en cotutelle entre le
Laboratoire Réactions et Génie des Procédés (LRGP) et L'École Nationale d'Ingénieurs de …

[引用][C] Investigating the effect of air volume fraction on the velocity distributions of air-water flow in a pipe separator

EA Afolabi, JGM Lee - 2013 - International Journal of Science and …

[引用][C] Stereoscopic particle image velocimetry analysis of air-water flow in a pipe separator

EA Afolabi, JGM Lee - 2013 - … of Chemical Engineering (I. RE. CH …