[HTML][HTML] Preparation and tribological properties of WS2 solid lubricating coating with dense structure using HiPIMS
P Ying, H Sun, P Zhang, C Lin, T Yang, J Wu… - Journal of Materials …, 2024 - Elsevier
In this study, a dense WS 2 coating was deposited via high-power impulse magnetron
sputtering (HiPIMS) after solving the glow discharge problem, and it was compared with WS …
sputtering (HiPIMS) after solving the glow discharge problem, and it was compared with WS …
[HTML][HTML] Research on the chemical barrier and failure behavior of WS2 and WS2/Ti coatings under high-temperature conditions and the effects on the lifespan of …
Z Zhang, Z Tan, W Lu, S Yi, X Qin - Surface and Coatings Technology, 2023 - Elsevier
With its outstanding performance as a solid lubricant, WS 2 has found applications in cutting
tools. Diamond-coated tools often experience the formation of a graphite phase during …
tools. Diamond-coated tools often experience the formation of a graphite phase during …
On the formation of Ti2AlN MAX phase coatings and improvement in tool life by superimposing on tungsten carbide cutting tool for machining Ti-6Al-4V alloys
This paper presents the development of (002) textured Ti 2 AlN coated wear resistant tool
utilizing reactive magnetron co-sputtering. The Ti 2 AlN coating was developed in two …
utilizing reactive magnetron co-sputtering. The Ti 2 AlN coating was developed in two …
[HTML][HTML] Effect of Deposition Parameters on Micromechanical Properties and Machining Performance of CrN Coating for Wet Finish Turning of Ti6Al4V Alloy
This study aims to optimize the performance of CrN coatings deposited on WC cutting tools
for machining Ti6Al4V alloy, where the formation of built-up edge (BUE) is a prevalent and …
for machining Ti6Al4V alloy, where the formation of built-up edge (BUE) is a prevalent and …