This article presents an overview of the developments in stainless steels made since the
1990s. Some of the new applications that involve the use of stainless steel are also …

Friction stir processing (FSP) is a new technique that offers a green way of synthesizing
composites. FSP is usually used to produce a composite layer on a substrate. This layer is …

Abstract Hybrid Cu–ZrO 2/GNPs nanocomposites were successfully produced using powder
metallurgy technique. The effect of GNPs mass fraction, 0, 0.5, 1 and 1.5%, on the …

In this study, a new processing technique, friction stir processing (FSP) was used to
incorporate SiC and MoS 2 particles into the matrix of an A356 Al alloy to form surface hybrid …

The effect of carbon content on the microstructure and bonding properties of pure titanium
clad carbon steel plates was studied by performing hot-rolling bonding experiments on pure …

In the present paper, mechanical properties of multilayer coatings were investigated.
Titanium nitride/titanium carbide (TiN/TiC) multilayer coatings were prepared on the surface …

Friction stir processing (FSP) was utilized to produce surface composites by incorporating
nano-sized cerium oxide (CeO 2) and silicon carbide (SiC) particles individually and in …

Despite being softer and more expensive than TiC, which is usually the preferred choice for
reinforcements in a steel matrix, NbC has been shown to be a potential reinforcement for …

A design strategy is presented for the development of a laser-deposited Stellite 6 coating
with high ductility and low thermal fatigue crack propagation rate. The strategy involved …

Titanium carbide (TiC) particulates-reinforced iron matrix composites were prepared by in
situ fabrication method combining an infiltration casting with a subsequent heat treatment …