Nowadays, fabrication of metal matrix composites (MMCs) with high mechanical properties
and modified microstructures has attracted many attentions. One of the methods to produce …

The creep-fatigue interaction has been recognized as the main failure mode of most
structural components operating in the high-temperature regime. The cyclic life (N f) usually …

H13 tool steel was deposited using the additive manufacturing technique Direct Metal
Deposition to produce a part having a wedge geometry. The wedge was characterized both …

Inorganic alkali lead iodide semiconducting APbI3 (A = Li, Na, K, Cs) and NH4PbI3 films
prepared from solution: Structure, morph Page 1 AIMS Materials Science, 3(3): 737-755. DOI …

The aging response of two Al-3Mg alloys with Cu addition< 1 wt% has been tracked under
simulated automotive paint bake conditions (∼ 20 min, 160 and 200° C) to quantify the …

Alloy 709 is a leading candidate structural material for sodium-cooled fast spectrum reactors
(FSR), where creep-fatigue is a potential failure mode. Low cycle fatigue (LCF) and creep …

In the present work, the bake hardening behavior of Al7075 was investigated using the
response surface methodology (RSM). The optimal conditions to attain the maximum bake …

AlMgCu alloy samples with 70 wt.% Al and varying Cu and Mg compositions have been
fabricated. The fabricated samples were characterized by x-ray diffraction measurement and …

Silver (Ag)‐based materials are considered to be promising materials for electrochemical
reduction of CO2 to produce CO, but the selectivity and efficiency of traditional …

In this paper, the phase composition and content of Al-30 wt% Mg 2 Si composite prepared
by in-situ process have been investigated; and the effect of different addition of La …