Oxide dispersion strengthened (ODS) alloys are characterized by nanoscale oxide particles
homogeneously dispersed in a metallic matrix. They have been developed driven by …

Abstract The Inconel 625 coatings with Nb addition of 0%, 1.5%, 3% and 5% were prepared
by laser cladding technology. The effects of different contents of Nb on the phase …

To improve microhardness and tribological properties of IN718, WC-12Co particles were
added to it by the laser cladding. This study investigated the effect of the content of WC …

In this research, in-situ synthesized NbC in the WCoB–TiC composite coating was fabricated
via laser cladding with variable laser power. The microstructure, elemental distribution …

This review article discusses about the development of nanocomposite coating on surfaces
of metallic materials produced by laser surface cladding and alloying process. The purpose …

Due to ever-present applied pressure and thermal shocks, forged dies are in danger of
durability and hardness reduction, surface cracks formation, and failure. Therefore, this study …

Few attempts have been made so far to develop modifiers for in situ use in Inconel 718 PBF-
LB/M fabrication. Reports show an increase in tensile strength compared to unmodified …

In order to improve the corrosive-wear and electrochemical properties of Ti6Al4V alloy,
CoCrFeNiMo-B 4 C coatings were prepared on its surface by laser cladding (LC). The …

Inconel 625 alloy cladding layer was prepared by high-speed laser cladding (HLC) on
Q245R steel substrate to improve the service performance of the structural components in …

Babbitt alloy, a commonly used wear-resistant coating material, has a low hardness. This
causes severe plastic deformation, detachment or heavy wear to easily occur under low …