Optimizing machining parameters is crucial, enhancing machinability while maintaining high
product quality standards. This study bridges a critical research gap by evaluating and …

The goal of this project is to use CNC end milling operations to process AL 6063 composites
reinforced with varying weight percentages of Nano TiO2 (1, 3 and 5). The composites are …

This article deals with the influence of the mold material on the segregation process in
selected Al-Si alloys. Three types of Al-Si alloys were chosen in order to compare the …

Bu çalışmada, farklı oranlarda (% 0, 02; 0, 1 ve 1) stronsiyum (Sr) içeren üç adet Al-12Si-Sr
alaşımı kokil kalıba döküm yöntemiyle üretildi. Üretilen alaşımların içyapıları standart …

In this study, Al-7Si-Mg and Al-7Si-0.6 Mg alloys were produced by permanent mold casting
method and their microstructural, mechanical and machinability properties were analyzed …

Bu çalışmada, farklı oranlarda (% 0, 02; 0, 1 ve 1) stronsiyum (Sr) içeren üç adet Al-12Si-Sr
alaşımı kokil kalıba döküm yöntemiyle üretildi. Üretilen alaşımların içyapıları metalografik …

This article deals with the issue of silumin inoculation. Two alloys, AlSi7Mg0. 3 and AlSi10.
5Cu1. 2Mn0. 8Ni1. 2, were selected. 4 pieces of castings were cast from each alloy. One …

Purpose: In this study, it was aimed to investigate the effect of strontium (Sr) additions at
different rates (0.02; 0.1 and 1%) on the cutting force, surface roughness and BUE (Built up …