Abstract Fabrication of the Mg–9Al–1Zn–0.5 Mn alloy with excellent mechanical
performance using selective laser melting (SLM) technology is quite difficult owing to the …

The objective of this study is to evaluate the effect of AM process on the microstructure and
properties of PH 13-8 Mo steel in the as-printed and aged conditions. Samples were …

An anisotropic microstructure and mechanical properties are big challenges in the
development of various laser powder bed fusion (LPBF) alloys. This study investigated the …

In the current study, cylindrical rods of Fe–Cr–Ni–Al maraging steel (with the brand name
CX) are fabricated using the laser-powder bed fusion (L-PBF) technique. The material is …

The scratch and reciprocating sliding wear response of a PH 13-8Mo stainless steel
fabricated by wire arc additive manufacturing (WAAM) are investigated after different cycles …

Various spraying techniques have been used to apply engineered coatings on different
industrial parts and components. Enhancing the properties of coated components for …

The PH 13-8 Mo family of steels belong to the martensitic precipitation hardening stainless
steels (MPHSSs) category, which exhibits a good combination of mechanical properties and …

Aging is indispensable for balancing the strength and ductility of selective laser melted
(SLM) precipitation hardening steels. This work investigated the influence of aging …

Metal additive manufacturing (AM) has been evolving in response to industrial and social
challenges. However, new materials are hindered in these technologies due to the …

The aim of this work is to evaluate the effect of three post-processing heat treatments (HT),
from 650 to 1100° C, on the high-temperature oxidation of laser powder bed fusion (L-PBF) …