A combined friction energy and tribo-oxidation formulation to describe the high temperature fretting wear response of a cobalt-based alloy
A cobalt-based superalloy (HS25) versus alumina contact was subjected to gross slip
fretting using a cross-cylinders configuration and various tribological conditions. The present …
fretting using a cross-cylinders configuration and various tribological conditions. The present …
Fabrication of 10 mm diameter fully dense Al86Ni6Y4. 5Co2La1. 5 bulk metallic glass with high fracturestrength
Fully dense amorphous Al86Ni6Y4. 5Co2La1. 5 alloy with a 10mm diameter has been
fabricated by spark plasma sintering (SPS). It showed record fracture strength of 1250MPa …
fabricated by spark plasma sintering (SPS). It showed record fracture strength of 1250MPa …
Dynamic recrystallization in sintered cobalt during high-temperature deformation
The constitutive flow behavior of sintered cobalt in the temperature range 873 to 1473 K
(600 to 1200° C) and at strain rates from 0.001 to 10 s− 1 has been studied using constant …
(600 to 1200° C) and at strain rates from 0.001 to 10 s− 1 has been studied using constant …
Sintering kinetics study of mechanically alloyed nanocrystalline Mo–30 wt.% W
The paper details the results of sintering kinetics studies conducted on nanocrystalline Mo–
30wt.% W alloy powders prepared through mechanical alloying route. Both, constant rate of …
30wt.% W alloy powders prepared through mechanical alloying route. Both, constant rate of …
Sintering Analysis of CoCrMo Powders by in-Situ Dilatometry
AM Garcia-Carrillo, J Lemus-Ruiz, L Olmos - Materials Research, 2024 - SciELO Brasil
The sintering kinetics of CoCrMo powders is investigated by dilatometry. Pre-alloyed
spherical powders were axially compacted and sintered between 1300° C and 1375° C …
spherical powders were axially compacted and sintered between 1300° C and 1375° C …
Evaluating the sintering kinetics of porous SiC ceramics
J Liu, X Zhang, H Wu, J Hu, Z Wan, Y Feng - Refractories and Industrial …, 2015 - Springer
Porous ceramics made by burning out a pore-former during the sintering process were
investigated by stepwise isothermal dilatometry (SID), x-ray diffraction (XRD) phase …
investigated by stepwise isothermal dilatometry (SID), x-ray diffraction (XRD) phase …
Isothermal dynamic thermal diffusivity studies of the reduction of NiO and NiWO4 precursors by hydrogen
HM Ahmed, S Seetharaman - International journal of materials …, 2011 - degruyter.com
Thermal diffusivity measurements of uniaxially cold pressed NiO and NiWO4 were carried
out in a dynamic mode in order to monitor the kinetics of hydrogen reduction of the above …
out in a dynamic mode in order to monitor the kinetics of hydrogen reduction of the above …
ОСОБЕННОСТИ ВЛИЯНИЯ НАНОМОДИФИЦИРОВАНИЯ НА СВОЙСТВА СВЯЗКИ Cu–Fe–Co–Ni ДЛЯ АЛМАЗНОГО ИНСТРУМЕНТА
ПА Логинов, ВВ Курбаткина, ЕА Левашов… - Известия вузов …, 2015 - powder.misis.ru
Аннотация Изучены особенности влияния наноразмерных добавок WC, ZrO 2, а также
микрометровых частиц гексагонального BN на уплотняемость при холодном …
микрометровых частиц гексагонального BN на уплотняемость при холодном …
Characterization of CoCrMo alloy fabricated by sintering for biomedical materials
J Lemus-Ruiz, AM Garcia-Carrillo, JL Cabezas-Villa… - MRS Advances, 2023 - Springer
The sintering kinetics of CoCrMo powders is investigated by dilatometry. Pre-alloyed
spherical powders were pressed and then sintered between 1300 and 1375° C. SEM …
spherical powders were pressed and then sintered between 1300 and 1375° C. SEM …
Peculiarities of the influence of nanomodification on the properties of the Cu–Fe–Co–Ni binder for a diamond tool
PA Loginov, VV Kurbatkina, EA Levashov… - Russian Journal of Non …, 2015 - Springer
The peculiarities of the influence of nanodimensional additives of WC, ZrO 2, and
micrometer particles of hexagonal BN on the compression ratio under cold pressing of …
micrometer particles of hexagonal BN on the compression ratio under cold pressing of …