This paper focuses on the comparing the resulting surface after finishing holes machined
with different cutting technologies. The machined material is Polyoxymethylene polymer …

There are many strategies that the operator can use for hole finishing, depending on the
equipment available to him. The issue at hand is choosing the optimal strategy when …

In this paper are presented two kinematic structures able to move/rotate along/around tree
axis each simultaneous. These two structures are restricted on a common fix bed and have …

The main objective of the paper consists in remanufacturing of a part, through Abrasive
Water Jet Cutting, using a method of reverse engineering based on 3D scanning. The …

This paper presents the process of manufacturing an injection mold, starting with the design
of the part, the design for the cavity plate, followed by the simulation of the injection molding …

The paper presents the manufacturing process of a complex copper electrode. To process
complex copper shapes is difficult because the material is soft and very sticky. The paper …

Silicone rubber flexible molds are used to obtain parts for small volume production. The use
of molds, after long periods of time, leads to the possibility that mold material aging …

While machining parts, the errors occurs due to factors with a systematic or a random
character. Among these factors, the errors due to clamping devices have a systematic …