DC–DC converters with voltage boost capability are widely used in a large number of power
conversion applications, from fraction-of-volt to tens of thousands of volts at power levels …

Over the last few decennia, power DC/DC converters have been the subject of great interest
due to its extensive increment of utilization in different applications. A thorough review on …

A controller design methodology for a quadratic boost converter with a single active switch is
developed. This converter has two LC filters; thus, it will exhibit fourth-order characteristic …

The need of dc-dc switching converters for power supplies with high-voltage gains has
increased in the recent years due to new applications in areas as renewable energy …

Over the last decade, dc–dc power converters have attracted significant attention due to their
increased use in a number of applications from aerospace to renewable energy. The interest …

The major challenges of the high-gain DC–DC boost converters are high-voltage stress on
the switch, extreme duty ratio operation, diode reverse-recovery and converter efficiency …

The voltage-lift technique is an effective method that could be applied in electronic circuit
design. A set of positive output DC–DC converters applying series SEPIC implementing …

In the past years, the development of topologies with step‐up capacities has been important
to satisfy the new requirement of renewable source energy. This study presents a quadratic …

In this article, an ultrahigh step-up quadratic boost converter based on coupled-inductor is
proposed. The voltage gain of the proposed converter can be enhanced significantly by …

In recent years, the development of new technologies is requiring wider conversion ratios. A
possible solution to this problem is to use n-conventional converters connected in cascade; …