The machining of duplex stainless steel usually involves the application of cutting fluids,
which consequently leads to negative ecologic, environmental and health impacts …

The research work was carried out on the end milling of Al 6082-T6 alloy with cryogenic
CO2, LN2 and wet conditions. The highest axial force (Fz), normal force (Fy) and feed force …

Due to the excellent properties of Ti-6Al-4V titanium alloy such as lightweight, high wear and
corrosion resistance and able to maintain high strength at high elevated temperature, this …

In manufacturing industries, machining is considered as one of the most significant and
effective processes. During machining process, cutting zone experiences the higher …

In this paper cemented carbide cutting insert with the variation of cobalt alloy has been
developed through sintering via microwave radiation processing technique. The Compact …

Superduplex stainless steels (SDSS) are used to manufacture components in the oil and
gas extraction industries. Machining of SDSS is difficult due to both built-up edge (BUE) …

Currently, cryogenic coolants are used instead of normal cutting fluid in transferring
excessive heat from the cutting region and retaining cutting tool edge sharpness during the …

The use of thin film diamond as a hard tool coating offers a significant wear protection in
numerous machining operations and increases considerably tool's lifetime. The extreme …

Duplex stainless steels (DSSs) use in many applications because of their superior
properties like high corrosion, good strength, and low cost. On the other hand, machinability …

The paper presents the results of experimental studies during machining of UNS S32750
alloy by using uncoated and coated carbide inserts. Wear and failure mechanisms were …