Effect of heat treatment on the microstructures and mechanical properties of Al-5.5 Zn-2.5 Mg alloy
Abstract The Al-5.5 Zn-2.5 Mg (wt%) ternary alloy was prepared using a vacuum melting
furnace and a casting furnace. Microstructural and mechanical properties of the alloy were …
furnace and a casting furnace. Microstructural and mechanical properties of the alloy were …
Wire and Arc additive manufacturing of high-strength Al–Zn–Mg aluminum alloy
High-strength 7xxx series aluminum alloys are of great importance for the aerospace
industries. However, this type of aluminum alloys has poor processability for most additive …
industries. However, this type of aluminum alloys has poor processability for most additive …
Characterization of microstructures obtained in wedge shaped Al–Zn–Mg ingots
MA Suarez, O Alvarez, MA Alvarez… - Journal of Alloys and …, 2010 - Elsevier
The structure present in chill casting taper section of Al–5.3 at.% Zn+ Mg additions between
3 and 40at.% Mg have been studied by scanning electron microscopy, microanalysis and X …
3 and 40at.% Mg have been studied by scanning electron microscopy, microanalysis and X …
Effects of cooling rate and component on the microstructure and mechanical properties of Mg–Zn–Y alloys
S Shao, Y Liu, CS Xu, YX Xu, B Wu, XS Zeng… - Acta Metallurgica Sinica …, 2015 - Springer
The microstructure and mechanical properties of Mg–6Zn–1Y and Mg–6Zn–3Y (wt%) alloys
under different cooling rates were investigated. The results show that the second dendrite …
under different cooling rates were investigated. The results show that the second dendrite …