Small wind turbines operating in low wind speed regions have not had any significant
success. In addition, small wind speed regions occupy a large area of the world, so they …

Abstract TRUAVs (Tilt Rotor Unmanned Aerial Vehicles) are a new technology that is
becoming more and more popular in today's modern world for a range of uses, including …

The composite materials extensively used in a CNC machine bed have a huge impact on
the efficiency and accuracy of the part. Existing materials, such as steel and cast iron are …

This paper presents an evaluation of five different turbulence models by comparing the
numerical data derived from these models using ANSYS Fluent with experimental data at a …

Numerical investigation was made to study the aerodynamic characteristics of the Tubercle
NACA2412 airfoil is used in the design of aircraft wing and wind turbine blades. In this …

Renewable energy has received strong attention and investment to replace fossil energy
sources and reduce greenhouse gas emissions. Quite good and good wind speed areas …

Faulty control surface actuator in a small Unmanned Aerial Vehicles (sUAV) could be
overcome with a few techniques. Redundant actuators, analytical redundancy or …

This work presents the studies obtained using OpenFOAM OpenSource Computational Fluid
Dynamics (CFD) Software. Experiments were performed to predict lift coefficient and drag …

Розглянуто питання щодо впливу форми обичайки вхідного пристрою на його
характеристики та структуру потоку на вході до компресора двигуна. Наводяться …

Airfoils are the cross-section of the wing or blade. Extensive research in the maximum L/D
ratio is crucial as faster travel is the need of the hour for developing faster and more efficient …