Most industrial alloys contain a matrix phase and dispersed second-phase particles. Several
thermomechanical processing (TMP) steps are usually needed to produce a final product …

High-temperature resistant material is becoming increasingly significant in numerous
industrial applications, including aerospace and automotive use, to increase fuel efficiency …

ABSTRACT Commercial precipitation-hardened Al-Cu alloys are normally used at
temperatures below its ageing temperature of∼ 225° C, to avoid thermally induced …

The deformation mechanism of an eutectic high-entropy alloy (EHEA) AlCoCrFeNi 2.1 at
elevated temperature has been studied by tensile test, microstructure analysis and …

The hot deformation behavior of homogenized AA2070 Al–Li–Cu alloy was studied using
isothermal compression in a temperature range of 300° C–500° C and a strain rate range of …

Exposure of Al–Cu–Mg alloys to an elastic loading, either for “creep age forming” or other
manufacturing processes at relatively high temperature, will lead to microstructural changes …

The hot compression tests of AA7050 aluminum alloy were conducted under conditions of
603–693 K and 0.001–10 s− 1, and the related microstructures were observed. Physically …

The influence of microalloying with Mg (0–0.36 wt%) on the elevated-temperature strength
and creep resistance of Al–Cu 224 cast alloys was investigated. The Mg-containing alloys …

In this paper, the dynamic precipitation and dynamic recrystallization (DRX) behaviors of Mg-
7Gd-2Nd-0.5 Zr (wt.%) alloy during thermal compression were investigated by optical …

The creep response of solder joints in a microelectronic package, which are subjected to
aggressive thermo-mechanical cycling (TMC) during service, often limits the reliability of the …