Abstract Al-Ti-Nb-B refiner shows excellent grain refinement effect for Al-Si alloys compared
to Al-5Ti-B refiner, but the addition of Nb increases the cost of production. This paper …

Heat-resistant aluminum alloys are widely used in aerospace and automotive fields for
manufacturing hot components due to their advantages in lightweight design and energy …

This study investigates the creep behavior of a cast, coarse-grained Al-12.5 wt.% Ce (Al-2.7
at.% Ce) alloy, consisting of an eutectic microstructure (α-Al with~ 11 vol.% submicron Al 11 …

The rare earth influence on the as-cast microstructures and mechanical properties of
aluminum alloys attracted great attentions in the last decades. But up to date no reports can …

Hot tensile test was performed at deformation conditions of 150–° C 300° C and 8.33× 10− 5
s− 1~ 1.67× 10− 3 s− 1, respectively, to systematically study the microstructure development …

The evolution of microstructure and mechanical properties of Al-7Si-0.4 Mg alloys doped
with La/Zr/La+ Zr was investigated by experimental characterization and thermodynamic …

Abstract A ternary Al-6.9 Ce-9.3 Mg (wt.%) hypoeutectic alloy, consisting of equal amounts of
α-Al (Mg) solid-solution regions and Al (Mg)-Al 11 Ce 3 eutectic colonies, is investigated in …

A low-cost, new casting Sr-modified Al-7.5 Si-0.8 Fe alloy with high-thermal conductivity was
prepared into large thin-wall heat-dissipating shells for 5G communication base stations …

The influence of ε-Al 3 Ni phase on tensile and creep performance of the Al–12Si-0.9 Cu-0.8
Mg-(1–4) Ni alloys was investigated at elevated temperature. The Image-Pro Plus was used …

Abstract Al–Si–Cu–Mg foundry alloys are used in casting process technologies. However,
their strength properties remain low due to their microstructural characteristics and porosity …