The article presents an original machine-learning-based automated approach for controlling
the process of machining of low-rigidity shafts using artificial intelligence methods. Three …

The paper presents a method combining the processes of straightening and thermal
treatment. Technological processes with axial strain were considered, for the case of heated …

The paper presents a method of modelling roughness parameters in the process of low-
rigidity elastic-deformable shafts turning. The developed model assumes that the cutting tool …

The article presents original technological methods that allow the improvement of the
accuracy of the turning and grinding of elastic-deformable shafts by increasing their stiffness …

The article presents a new thermo-mechanical machining method for the manufacture of
long low-rigidity shafts which combines straightening and heat treatment operations. A …

So far, due to much more strict events of operating parameters requirements, the reduction
of pieces steel intensity allows to produce multiplying quantity of the highly precise Non …

The paper describes the development of a procedure for increasing the accuracy of
processing thin-walled parts. The paper proposes a new method for fixing and processing …

In present paper there is the refinement method of the non-rigid shafts turning work meant to
be provided. There are foundations to the axial forces control necessity gained. The unit that …

The article presents the results of the experimental validation of the developed static, time
and frequency characteristics under interference and longitudinal feed control of a dynamic …

The comparative thermography analysis of temperature during machining by turning was
presented. For the tests cast iron EN-GJL 250 and stainless steel 1.4301 were used. The …