To better understand the elevated temperature flow behaviors of 30Si2MnCrMoVE low-alloy
ultra-high strength steel, hot compressive deformation tests were performed at a wide range …

In the present investigation, the effect of microstructure and texture on the evolution of
mechanical properties during recrystallization for 80% unidirectionally cold rolled UNS …

The present study describes the hot deformation behaviour of a novel Ti–6Al–4Mo–1V–0.1
Si alloy. The flow characteristics of the alloy were investigated in the strain rate range of 0.01 …

UNS S32101 lean duplex stainless steel (DSS) has a two phase microstructure consisting of
austenite and ferrite in near equal proportions. Aging at high temperature results in …

In the present work, Al3Zr/Al composite was fabricated through the in situ route. The
fabricated composite was isothermally forged in the temperature and deformation rate range …

A series of thermal compression tests on a Cr-Mn-Si-Ni alloyed naval steel were carried out
at different strain rates (0.0005–0.0100 s− 1) at different temperatures (1023–1173 K) …

In recent years, electric vehicles (EVs) have grown in popularity as a viable way to reduce
greenhouse gas emissions by replacing conventional vehicles. The need for EV batteries is …

In the present work, the effect of long-term aging at 750° C up to 480 h on microstructure
evolution, texture development and corrosion behavior of a low molybdenum Fe–21Cr-1.5 …

The effect of weld chemistry (two types of electrodes (E2594 and E2595)) on the
microstructure and texture development using electron back scattered diffraction and …

In the presented research, the dynamic working of nickel-based (IN600) superalloy was
performed and the micro-mechanisms affecting the deformation behaviour were closely …