Gray cast iron (GCI) is a popular automotive brake disc material by virtue of its high melting
point as well as excellent heat storage and damping capability. GCI is also attractive …

In this work, different Al 2 O 3–TiO 2 coatings, ie, Al 2 O 3, Al 2 O 3-13 wt.% TiO 2 and Al 2 O
3-40 wt.% TiO 2, produced by various thermal spray processes, namely:(i) atmospheric …

This paper discusses the influence of using 13 wt% of TiO 2 addition to Al 2 O 3 powder and
selection of plasma spray parameters on morphology, microstructure, phase composition …

Hybrid plasma spraying combines deposition of coarse dry powders and liquids, ie,
suspensions or solutions, thus expanding range of microstructures and functional properties …

In this study, the conventional air plasma spraying (APS) technology was employed to
deposit Al 2 O 3 coatings with varying TiO 2 contents (AT coatings) on a Ti80 substrate. The …

The attractive properties achieved by Suspension Plasma Spraying (SPS), combined with
the availability of high throughput capable plasma spray systems that permit axial feeding …

Nowadays thermal spraying of coatings is a relevant issue in the surface industry [1]. A lot of
attention is paid to the complex deposits, derived from powders which are composed of …

Abstract Al 2 O 3-40 wt% TiO 2 (AT40) coating is a low-cost and widely applied ceramic
coating. In this article, the phase distribution, micro-hardness and wear mechanism, as well …

Abstract Al 2 O 3–TiO 2 coatings have been deposited by atmospheric plasma spraying from
agglomerated, nanostructured powders showing better properties than those of their …

Al2O3 coatings were applied on the surface of 12Ch18N10T steel by the detonation method
at different degrees of filling of the detonation gun. The aim was to study the influence of …