Green ceramic machining (GCM) has been investigated as an alternative method for the
mould-free fabrication of complex-shaped ceramics, where ceramics in 'unsintered'green …

Crankshaft fatigue problem has long been a headache and frequent phenomenon in
combustion engine which attracts various efforts especially including fundamental fatigue …

Present work proposes a recycling form of multilayer food packages to avoid their
incineration, landfill of wastes or re-using of their individual components. The manufacturing …

The mechanical behavior of test pieces extracted from two specimens of Pinus halepensis
Mill., from the same geographical area and close to each other, was examined in this study …

The feasibility of sintering Portland cement clinker powders by Spark Plasma Sintering
(SPS) has been studied. Different SPSed compacts have been successfully obtained by this …

Mechanical properties of pressureless sintered 0.15–1.2 vol.% multiwalled carbon nanotube
reinforced alumina matrix nanocomposites have been analyzed using the 2-parameter …

The distribution of a given set of data is important since most parametric statistical tests are
based on the assumption that the studied data are normal distributed. In analysis of fracture …

摘要 The reliability of 2D C/SiC composite was investigated by the methods of probability
together with statistics, including the analysis of flexural strength, the comparison of …

以采用化学气相渗透法(CVI) 制备的SiC 纤维和C 纤维混杂增韧SiC 基复合材料((SiC-C)/SiC)
的弯曲强度数据为依据, 以Weibull 分布为假设, 采用图解法结合逐步回归优选法进行参数估计 …