This The article deals with the modeling of separation processes in a multifunctional oil-gas
separator of “HEATER-TREATER” type, which allow effectively separating a gas-liquid …

AlCrTiN coatings were obtained by radio frequency magnetron sputtering and deposited on
aluminum-silicon alloy substrates (A4032). The microstructure, morphology and chemical …

Experimental studies indicate that the maximum stress acted on the top portion of the piston
and stress concentration is also the main cause of fatigue failure. This article discusses the …

Multi-cycle direct numerical simulations (DNS) of a laboratory-scale engine at technically
relevant engine speeds (1500 and 2500 rpm) are performed to investigate the transient …

The major contributor of pollution in the environment has been because of the transportation
sector. Compression ignition engine has been a popular engine in the transportation sector …

Sebagai bagian utama dari mesin pembakaran dalam, piston berfungsi sebagai penggerak
utama pada mesin pembakaran dalam, yaitu memindahkan tenaga yang dihasilkan oleh …

Piston failure is caused by a combination of mechanical and thermal loads is a frequent
occurrence that can be expensive to repair or replace. In this paper, analysis is carried out to …

Traditionally, most simulation approaches for pistons are conducted based on thermal-
structure coupling, where the cooling boundary conditions are determined by empirical …

The main objective of this research was to examine the suitability of aluminium alloy to
design a piston of an internal combustion engine for improvement in weight and cost …

The main purpose of the preliminary analyses presented in the book is to compare the
behavior of the combustion engine piston made of different types of material under thermal …