Microwave sintering has emerged in recent years as a new method for sintering a variety of
materials that has shown significant advantages against conventional sintering procedures …

The effect of processing on the dielectric properties of CaCu3Ti4O12 (CCTO) was
researched. CaCu3Ti4O12 was prepared using conventional ceramic solid state reaction …

CaCu3Ti4O12 (CCTO) ceramics with high dielectric constant (2–4× 104) and low loss (0.04)
were prepared by the sol–gel process and sintered at 1050° C for different times. The …

BiVO 4 thin films have been prepared through radio frequency (rf) magnetron sputtering of a
pre-fabricated BiVO 4 target on ITO coated glass (ITO-glass) substrate and bare glass …

Using tetrabutyl titanate, calcium nitrate and copper nitrate, a gel of these compounds was
obtained at room temperature which on subsequent heat treatments led to CaCu3Ti4O12 …

CaCu 3 Ti 4 O 12 precursor powders were synthesized by the sol–gel process. The
optimized processing parameters for the synthesis of precursor powders were as follows: the …

The Ca1− xSrxCu3Ti4O12 (CSCTO) giant dielectric ceramics were prepared by
conventional solid-state method. X-ray diffraction patterns revealed that a small amount of …

Colossal permittivity (CP) materials have great application prospects in electronic devices.
However, obtaining a giant dielectric constant, low dielectric loss, and good temperature …

Detailed investigations into the dielectric dispersion phenomenon in the giant dielectric
constant material CaCu3Ti4O12 (CCTO) around room temperature revealed the existence …

Due to the continuous demand for miniaturization of electronics, there is an interest in
developing dielectric materials with higher permittivity. Recently, the CaCu3Ti4O12 (CCTO) …