X Xu, H Ding, H Huang, H Liang, H Guo, R Chen… - Journal of Materials …, 2022 - Elsevier
The creep behavior of a directionally solidified TiAl alloy with a high Nb content after microalloying by the addition of small amounts of W, Cr, and B elements was investigated by …
Y Chen, B Gou, X Xu, X Ding, J Sun, EKH Salje - Additive Manufacturing, 2023 - Elsevier
The multiple collapse mechanisms of complex materials produced by additive manufacturing (AM) were identified by measurements of the acoustic emission (AE) of the …
Q Wang, X Wu, X Liu, L Zeng, H Ding, R Chen… - Journal of Alloys and …, 2023 - Elsevier
Heat treatment is an effective post-processing method to modify the microstructure and mechanical properties of TiAl alloys. Thus, we report the influences of a heat treatment at …
S Yang, C Cui, S Cui, S Liu, Y Liang - Materials Science and Engineering: A, 2022 - Elsevier
An in-situ dual morphology Ti 8 C 5/TiB 2 reinforced TiAl composite (DMTTC) is prepared by adding the inoculant which is prepared by spark plasma sintering (SPS). In DMTTC, Ti 8 C 5 …
S Cui, C Cui, S Yang, S Liu - Materials Science and Engineering: A, 2022 - Elsevier
Abstract The Ti–48Al–6Nb alloy is reinforced by the addition of the AlMo/B 4 C inoculant powders after high-energy ball milling. The in-situ reactions in TiAl melt lead to the formation …
CK Soundararajan, A Myhre, A Sendrowicz… - Materials Science and …, 2023 - Elsevier
Hydrogen embrittlement susceptibility of nickel alloy (Inconel 625) is examined by a conventional strain rate tensile test (10− 3 s− 1) equipped with an acoustic emission (AE) …
The tensile behaviour of the biocompatible alloy Mg-1Zn-0.2 Ca (in wt.%) in the fine-grained state, obtained by severe plastic deformation via multiaxial isothermal forging, has been …
An in-depth understanding of the deformation behavior of a nanolamellar TiAl/Ti 3 Al composite is prerequisite to control the mechanical properties of this material. Nevertheless …
H Li, J Yu, W Jia, Q Lin, J Wu, G Chen - Journal of Materials Science & …, 2025 - Elsevier
Abstract Ti-2Al-2.5 Zr is widely used in piping and structural support applications, however, the rolling forming process results in anisotropic deformation during service. This behavior …