Traditionally, inertial measurement units-(IMU) based human joint angle estimation requires
a priori knowledge about sensor alignment or specific calibration motions. Furthermore …

Results: Data obtained showed that the mean values for all measured anthropometric
parameters including stature were higher in males than in females (P< 0.05). The correlation …

2. Materials and Methods In this study 36 intact adult human tibia (18 right sided and 18 left
sided) were obtained from the bone bank of Anatomy Department of NRI Institute of Medical …

Background: The tibia is the bone that is mostly fractured in the body. Surgical fixation of
tibia fractures with intramedullary (IM) nail is a common procedure around the world …

Background: The upper end of the tibia is beneficial for surgeons and biotechnologists. It is
additionally used by interventional rheumatologists in implanting for osteonecrosis of medial …

Background: In the domains of forensic science, anatomy, archaeology, and sports
medicine, morphometric data of long bones are important. The morphometry of the tibia is …

The use of body-worn inertial measurement units (IMUs) as an alternative to traditional
human optical motion capture (OMC) techniques has gained increasing attention over the …

Background: Estimation of stature can be done from long bones especially tibia and femur
as they have a correlation with height. Tibia is most commonly used as it resists erosion and …

The lower end of tibia along with its medial malleolus and the lateral malleolus of the fibula
form a deep recess to accommodate the body of talus. Measurements of distal end of tibia …

Background: The knee joint is commonly affected by osteoarthritis. Total Knee Replacement
(TKR) is usually considered for knee osteoarthritis after failure of conservative management …