Twin roll casting was commercialized for a strip production from ferrous and non-ferrous
alloys in the 1950s; however, its application to magnesium has proven difficult and still …

Asymmetric sheet rolling is a process used when there are differences in any technological
parameters in the horizontal plane across the width of the deformation zone or in the vertical …

The effects of the base lubricant with and without nanoparticles on the tribological behavior
of magnesium alloy/steel contacts were investigated using a reciprocating sliding ball-on-flat …

Pre-twinning was used to tailor the strength and ductility of AZ31 magnesium alloy.
Simultaneous enhancements in both ductility and strength were achieved in the AZ31 after …

Abstract In this work, Mg/Al laminated metal composites with different thickness ratios were
prepared by a two-pass rolling process combining asymmetrical rolling with differential …

Strength and ductility synergy in an Mg-3mass% Al-Mn (AM30) alloy sheet was successfully
improved via twin-roll casting and annealing at low-temperature. An AM30 alloy sheet …

In this study, the changes in the microstructure, texture, and mechanical properties of the
AZ31B magnesium alloy sheet after asymmetric rolling (ASR) in different shear deformations …

In this research, the microstructure, texture, and mechanical properties of AZ91 magnesium
alloy during asymmetric hot rolling were investigated. Optical microscopy (OM), scanning …

Mg and its alloys have garnered significant attention due to their exceptional properties,
including low density, good damping capacity, biocompatibility, recyclability, and high …

Twin-roll casting (TRC) of Mg alloys with high Al content has unique advantages and broad
development prospects. However, the severe segregation of high-alloyed Mg caused by …