Event-based processing of neutron scattering data at the Spallation Neutron Source
The Spallation Neutron Source at Oak Ridge National Laboratory, USA, ushered in a new
era of neutron scattering experiments through the use of event-based data. Tagging each …
era of neutron scattering experiments through the use of event-based data. Tagging each …
Martensitic transformation of an austenitic stainless steel under non-proportional cyclic loading
In this study, a series of cyclic tests on a 304L stainless steel with different loading paths
were conducted. It revealed that as the non-proportionality of loading path increased, the …
were conducted. It revealed that as the non-proportionality of loading path increased, the …
Unraveling cyclic deformation mechanisms of a rolled magnesium alloy using in situ neutron diffraction
In the current study, the deformation mechanisms of a rolled magnesium alloy were
investigated under cyclic loading using real-time in situ neutron diffraction under a …
investigated under cyclic loading using real-time in situ neutron diffraction under a …
A cyclic plasticity model for secondary hardening due to strain-induced martensitic transformation
A model for secondary cyclic hardening due to strain-induced martensitic transformation in
metastable austenitic stainless steels is proposed. The model is built on an Armstrong …
metastable austenitic stainless steels is proposed. The model is built on an Armstrong …
Effect of tensile overload on fatigue crack behavior of 2205 duplex stainless steel: Experiment and finite element simulation
W Zhang, W Jiang, H Li, M Song, Y Yu, G Sun… - International Journal of …, 2019 - Elsevier
The effect of tensile overload on fatigue crack behaviors of 2205 duplex stainless steel has
been studied by experimental and finite element methods (FEM). The residual stresses were …
been studied by experimental and finite element methods (FEM). The residual stresses were …
The large volume press facility at ID06 beamline of the European synchrotron radiation facility as a High Pressure-High Temperature deformation apparatus
J Guignard, WA Crichton - Review of Scientific Instruments, 2015 - pubs.aip.org
We report here the newly developed deformation setup offered by the 20MN (2000T) multi-
anvil press newly installed at sector 7 of the European synchrotron radiation facility, on the …
anvil press newly installed at sector 7 of the European synchrotron radiation facility, on the …
Real-time in situ neutron diffraction investigation of phase-specific load sharing in a cold-rolled TRIP sheet steel
Real-time in situ neutron diffraction was used to investigate the loading-direction
dependence of phase-specific load sharing in a cold-rolled TRIP 780 sheet steel under …
dependence of phase-specific load sharing in a cold-rolled TRIP 780 sheet steel under …
Superior strength and ductility in a low density duplex steel studied by in situ neutron diffraction
A low density, high strength medium-Mn steel was processed to produce a bimodal duplex
microstructure consisting of coarse grained γ-austenite with fine δ-ferrite grains decorating …
microstructure consisting of coarse grained γ-austenite with fine δ-ferrite grains decorating …
Understanding low-cycle fatigue life improvement mechanisms in a pre-twinned magnesium alloy
The mechanisms of fatigue life improvement by pre-twinning process in a commercial rolled
magnesium (Mg) alloy have been investigated using real-time in situ neutron diffraction …
magnesium (Mg) alloy have been investigated using real-time in situ neutron diffraction …
Effect of thermal aging on the low cycle fatigue behavior of Z3CN20. 09M cast duplex stainless steel
Abstract Nuclear grade Z3CN20. 09M cast duplex stainless steel exhibits enhanced cyclic
stress response and prolonged low cycle fatigue life at room temperature after thermal aging …
stress response and prolonged low cycle fatigue life at room temperature after thermal aging …